For HES 8000C installation manual, follow these general steps. Be sure to refer to the specific installation manual for detailed instructions, as procedures may vary slightly based on the model or the particular setup of your door:
TOOLS AND MATERIALS NEEDED
HES 8000C electric strike
Screwdriver (Phillips and flat-head)
Drill with appropriate bits (including a chisel bit if needed)
Measuring tape
Level
Wire connectors (if applicable)
Electrical power supply (12V or 24V as required)
INSTALLATION STEPS
Unscrew and remove the existing strike plate from the door frame.
Position the Strike: Place the HES Assa Abloy 8000C in the door frame where the old strike was located. Ensure that the strike aligns with the door’s latch bolt.
Mark Drilling Points: Use the strike as a template to mark the screw hole locations on the frame.
Drill Holes: Drill holes for the mounting screws.
Chisel Out Recess (if necessary): If the strike does not sit flush with the frame, chisel out a recess to accommodate it.
If your installation requires hardwiring:
Route Wiring: Feed the wiring through the pre-drilled hole (if applicable).
Connect Wires: Connect the strike to the power supply using the wire connectors. Follow the wiring diagram with the electric strike for correct connections (usually red for positive and black for negative).
- Place the HES 8000C installation manual into the recess and secure it using the screws provided.
- Ensure the strike is level and properly aligned with the door latch.
- Reconnect the power supply and test the electric strike to ensure it engages and releases correctly.
- Check that the door latch smoothly interacts with the strike.
- Reconnect the power supply and test the electric strike to ensure it engages and releases correctly.
- Check that the door latch smoothly interacts with the strike.
- If your model has a cover plate, install it to protect the wiring and components.
- Keep all manuals and warranty information for future reference.
HES 8000C INSTALLATION MANUAL ADDITIONAL TIPS
- Consult Manufacturer’s Instructions: For diagrams and specifications, always refer to the specific installation manual provided by HES Assa Abloy.
- Local Codes: Ensure compliance with local codes and regulations regarding electric strikes and door hardware.
- Power Supply: Use the correct voltage (12V or 24V) for your specific electric strike model.
INSTALLATION MANUAL
DOWNLOAD
HES 8000C PARTS
WHY IS IMPORTANT INSTALL A HES 8000C?
ENHANCED SECURITY
CONVENIENCE
DURABILITY AND REALIABILITY
INTEGRATION WITH ACCESS CONTROL SYSTEMS
AESTHETICS
FAIL-SAFE OPERATION
COST-EFFECTIVENESS
EASY MAINTENANCE
Installing a HES 8000C electric strike contributes to a more secure, efficient, and user-friendly access control solution.
